oil ran out on my shock, used about 100ml of fork oil motorex brand, oil seals are still in good shape so far no leaks, but shock is not yet installed for Assalamu Alaikum!Welcome to Hoque's Diary Channel.Honda Hornet Engine Sound Problem. Fork Seal Change. Front Break Pad Change. Carburettor Piston Change. Spa Keep this in mind as well for next time too, if you were using a 3/4" torque wrench, a 9 ft lbs reading is usually at the lowest end of the adjustment on the wrench, and the wrench is too big. I've never snapped a 6mm bolt at 9 ft lbs, and I've torqued a serious amount of 6mm bolts:thumb: Use a 1/4" torque wrench for 6mm bolts, OR snug. 2nd part these fork service / rebuild, in these video I assemble the forks and correctly adjust the oil level.In these video I clean, assemble, setup and fin 1) the pilot jets are 40s - Haynes manual says 40. 2) main jets are 105 and 108 - Haynes says 100 and 102. My question : 1) After cleaning them out will they be ok to use in the configuration they are in? Or are they the cause of lack of top speed / acceleration / hard starting / limited rpm. Middle Link Pipe Exhaust Muffler Slip-on 51mm System For Honda CB600F Hornet 600 (Fits: 2006 Honda CB600F) $107.48. Was: $126.45. LRLmotors. LRLmotors. Honda Hornet full service performance pack comes with Liqui Moly semi synthetic engine oil, engine flush, engine oil additive. Liqui Moly Performance pack will help to improve overall engine performance, engine smoothness, and extended engine life, Honda Hornet, Honda motorcycle service. How to change on your Honda CB600F Hornet.I used a K&N KN-303 oil filter and Motul 7100 fully synthetic oil (3,8L) SPARKPLUG change, on a HONDA Hornet, Honda 599, from 2010This is PART 2 how to put NEW spark plugs back into your Hornet.Ofcourse with a lot of hints and tip #claudetube #claudegarage #hondahornet Support the channel making a donation at VImUfn.